AC Servo Motor Coil Insertion Machine / Semi-autoArmature Winding
1. Model No.: QLB1-200/250
2. This machine is designed with a vertical frame.
3. It is controlled by PLC.
4. easy operation and convenient tooling change.
This machine is specially designed for the motor manufacturers who
have different sizes motor and need to change the tooling
frequently. The tooling change-over time is 20~30 minutes. It only
takes 1/4 time comparing the conventional machine. The wedge is
prepared by a wedge inserting machine, and operator transfers it to
the coil inserting machine, then the maThe tooling change-over time
is 20~30 minutes. It only takes 1/4 time comparing the conventional
machine. chine insert coil and wedge simultaneously into the
stator. The machine could set and save different data for different
stators. It could use different motor production and specially good
for the single phase and three phase induction motor manufacturers.
Stator stack length
Slot number range
|Tooling traveling distance||Max.110mm|
|Max. Slot filling rate||80%|
Machine main function and characteristic
The machine insert coil and wedge simultaneously, coil insertion is
controlled by servo motor system.
It is controlled by HMI, and machine can diagnose breakdown
Both copper wire and aluminium wire are applicable.
Production capacity ≤20s/set (exclude the man-hours for auxiliary
Primary qualification rate for copper wire ≥98%, after rework, the
Wire pushing height and stop time can be set in the HIM interface.
The machine has fixed foot and removable wheel.
Wedge should not be damaged, no burr in the surface, no movement or
Wedge should not be damaged, no movement or slide. Copper wire
should not be pull away from the paper.
The stator should not be deformation or stator lamination should
not be upward.
Easy operation and convenient tooling change. The tooling
change-over time is 20~30 minutes. It only takes 1/4 time comparing
the conventional machine.